Drywall cart — Thousand Oaks, CA

A drywall pole sander is designed for efficient sanding of large wall and ceiling surfaces. It consists of a sanding head attached to an extendable pole, allowing you to reach high areas without a ladder. The head swivels, enabling you to sand at different angles. Pros use it with abrasive screens to quickly smooth out drywall mud between coats. It significantly speeds up the sanding process compared to hand sanding.

Drywall bulges can occur if screws or nails used to attach the drywall to the studs have loosened or are not properly set. Sometimes, moisture can cause the drywall paper to expand, leading to a bulge. If the tape used at the seams wasn't applied correctly, it can also create a raised area. A professional will inspect the bulge to determine the cause. They can then re-secure the drywall, replace damaged sections, or re-tape and mud the area to create a smooth, flat surface.

Spackling small holes in drywall is a straightforward process. You'll need a small putty knife and some spackle. Apply a small amount of spackle to the knife and press it into the hole, ensuring it's filled completely. Then, smooth the surface with the knife, slightly overfilling to account for shrinkage as it dries. Once the spackle is dry, lightly sand it smooth with fine-grit sandpaper. For larger holes, more steps and materials might be required.

Drywall corner bead is essential for protecting and straightening outside corners. It's typically made of metal or vinyl and is attached by embedding it into drywall mud. A coat of mud is applied to the corner, the bead is pressed into it, and then more mud is applied over the bead's flanges. This process is repeated with multiple thin coats of mud, followed by sanding, to create a sharp, durable corner that's ready for paint.

While drywall screws are the preferred fastener for most modern installations due to their superior holding power and reduced risk of 'nail pops', nails can still be used. When nails are used, ring-shank drywall nails are recommended. The rings on the shank help prevent the nail from backing out over time, providing a more secure hold. They are designed to be driven slightly below the surface of the drywall paper.